Operation process

In daily life, the installation and application of the barcode carbon tape and barcode paper outside the barcode printer are very important. If the device is not properly installed, it also has a significant impact on the service life of the barcode printer. Moreover, it is often encountered that the carbon tape and label paper are stuck outside the printer, which can make it impossible to print in light cases, and even cause machine damage in severe cases.

So how do you install the carbon belt? Above, Dahema editor provides a detailed introduction for everyone:

1.When installing carbon tape and barcode paper, follow the device instructions in the printer.

Attention:

1) When installing the carbon belt device, it is necessary to distinguish the winding direction of the carbon belt and never install it upside down, otherwise it may damage the components of the printer. When installing the device, the carbon belt must be pushed away.

2) When installing the barcode paper device, it is necessary to block the "barcode paper stopper" and "paper stopper" properly. The barcode paper should pass under the "pressure paper/reflector", and the left side of the barcode paper should be against the "guide paper".

2. When installing barcode paper and carbon tape, be careful not to scratch the print head. For example, rings, tools, and other items. Barcode paper and carbon tape should not be adhered with mud, dust, debris, etc.

3.When the barcode paper is drawn into the drum above the print head, do not use a blade to scratch the barcode paper to avoid damaging the drum. You can only gradually reverse the rotation of the drum by hand to remove the barcode paper.

【 Go Back 】 | 【 Print 】